Lithium ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light and powerful. This battery is ideally used for portability of your prototype With Charging protection circuit

The battery includes following electrical characteristics.

• Output voltage – 3.7V
• Capacity – 350mAH
• Internal resistance 80 mOhm
• Charging constant – 250mA (0.5C)

Dimensions

• 25mm x 35mm x 5.5mm
  
• Cable length – 40 mm

Connector

• JST-PH – 2P

Do not over charge or fully discharge.

The included protection circuitry keeps the battery voltage from going too high (over-charging) or low (over-use) which means that the battery will cut-out when completely dead at 3.0V. It will also protect against output shorts. However, even with this protection, it is very important that you only use a LiIon/LiPoly constant-voltage/constant-current charger to recharge them and at a rate of 700mAH or less.
Like most lipos, the batteries we sell do not have thermistors built in. This is why we suggest charging at 1/2C or even less - 350mAH max in this case which is how much you can get from a USB port.

Wearable, eTextile and Adafruit Circuit Playground starter kits 

Bundle and Save 

Accessories